Web Audio · no audio files · no uploads
Eject water from your speaker
in 30 seconds.
Clean Speaker synthesises calibrated low-frequency tones in your browser that push water and dust out of the speaker mesh. Nothing is downloaded, uploaded or stored.
- Works offline
- iPhone & Android
- Free, no account
Device preset
Base 165 Hz
Channel
Haptic sync
Vibrate the chassis in time with the tone.
Stop where the speaker buzzes loudest — its resonant frequency.
Cleaning mode
Steady sine wave at the device's natural frequency.
Ready when you are
A 3-second chime to check for muffled or distorted audio.
Tilt guide
Let gravity help
Hold the phone at 45–90°, bottom speaker port facing the floor.
Tilt the laptop forward or onto its side so the grilles face the desk.
Hold the phone with the top earpiece facing the floor, screen toward you.
Keep the port pointing down for the whole cycle. Acoustic pressure loosens the droplets; gravity takes them out.
Clean Speaker
How acoustic ejection works
A speaker is a piston. Play a tone near its resonant frequency and the cone travels further, pushing air through the mesh on every stroke.
A low tone loads the cone
165 Hz moves a phone driver 165 times a second at full excursion.
Air clears the mesh
Each stroke pushes a puff of air out, breaking the surface tension in the droplets.
Gravity finishes the job
With the port facing down, loosened water falls away instead of settling back in.
Do & avoid
Do
- Unplug the charger before you start.
- Wipe the outside with a dry cloth.
- Play the tone with the speaker facing down.
Avoid
- Don't put the device in rice — dust gets into the ports.
- Don't use a hair dryer or direct sun.
- Don't poke the mesh with pins or cotton buds.
Questions
Does this actually work?
For water sitting in the speaker grille, yes. It cannot dry the inside of a phone — if the device is soaked or won't power on, get it serviced.
How long should I run it?
One to three cycles. If the sound is still muffled, let the device air-dry for a few hours and try again.
Is it safe for the speaker?
It is ordinary audio at normal levels, the same cone movement as bass in music. Keep sessions short and let the speaker rest between them.
Why is there no sound?
Raise the media volume, switch off Silent mode on iPhone, and disconnect Bluetooth. The tone has to play from the device itself.
Do you store anything?
No. Every tone is generated by your browser. No audio files, no accounts, no tracking of what you play.